QUESTIONNAIRE

KINDLY FURNISH THE FOLLOWING DETAILS TO ENABLE US TO QUOTE FOR A SUITABLE HYPO ROTARY GEAR PUMP.

APPLICATION
FLUID HANDLED

SPECIFIC GRAVITY OF THE FLUIED AT P.T.   
VISCOSITY OF THE FLUID AT P.T.
NATURE OF THE FLUID
PUMPING TEMPRETURE    
RATED DISCHARGE CAPACITY

PUMP NOZZLE SIZE – SUCTION  

 DELIVERY
RATED DISCHARGE PRESSURE
SUCTION PRESSURE /HEAD  
PUMP SPEED IN RPM
DUTY CONTINUOUSINTERMITTANT
DRIVE BY VENDOR PURCHASER
DRIVE    DIRECTR   PULLEYEDUCTION GEAR BOX
DRIVE RATING H.P.R.P.M.
TYPE OF ENCLOSUR   
LOCATION    OUTDOOR INDOOR.
DIRECTION OF ROTATION CLOCKWISEANTICLOCKWISE
OTHER ACCESSORIES
ANY OTHER SPECIAL REQUIREMENT:
NAME OF THE COMPANY
ADDRESS  
PHONE / FAX
CONTACT PERSON
EMAIL
COMMENTS :

 

IF YOU FOUND ANY DEFFICULTY TO FILL UP THE FORM THEN PLEASE DOWNLOAD AND THEN SEND IT BY POST OR COURIER OR EMAIL

[FrontPage Save Results Component]

 

DIMENSION Of HYPO FOOT MOUNTING GEAR PUMP

A : DISTANCE FROM PUMP BASE TO CENTER OF MAIN DRIVING SHAFT OF PUMP
B: DISTANCE FROM PUMP BASE TO CENTER OF SUCTION / DELIVERY PORT
C: DISTANCE BETWEEN SUCTION DELIVERY PORT
D: DISTANCE FROM SHAFT END TO CENTER OF SUCTION / DELIVERY PORT
E: DISTANCE FROM END OF FRONT COVER TO CENTER OF SUCTION / DELIVERY PORT
F: DISTANCE FROM CENTER OF PUMP SUCTION / DELIVERY PORT  TO END OF PUMP
G : PUMP DRIVING SHAFT DIAMETER
J : PUMP BASE MOUNTING DIAMETER
K: PUMP BASE MOUNTING DIAMETER
R: HOLE SIZE FOR BOLT BASE
U : OUT SIDE SHAFT EXTENSION
V : PUMP INLET / OUTLET, SUCTION / DELIVERY SIZE IN BSP  
DIRECTION OF ROTATION CLOCKWISE    ANTICLOCKWISE

PLEASE FILL UP THE FORM AS PER THE DRAWING ALL DIMENTIONS SHOULD BE IN MM

 

 

[FrontPage Save Results Component]

DIMENSION OF HYPO FLANGE MOUNTED GEAR PUMP

A : OUT SIDE DIAMENTER OF PUMP MOUNTING FLANGE
B: LOCATING DIAMETER OR SPIGOT DIAMETER OF PUMP MOUNTING FLANGE
C: DISTANCE BETWEEN SUCTION DELIVERY PORT
D: DISTANCE FROM SHAFT END TO CENTER OF PUMP INLET / OUTLET PORT
E: DISTANCE FROM PUMP MOUNTING FLANGE TO CENTER OF PUMP INLET / OUTLET PORT
F : DISTANCE FROM PUMP END TO CENTER OF PUMP INLET / OUTLET PORT
G: PUMP SHAFT DIAMETER
H : PUMP MOUNTING FLANGE THICKNESS
I : PUMP MOUNTING FLANGE LOCATING DIAMENTER / SPIGOT DIAMETER THICKNESS
L KEY WAY LENGTH ON SHAFT
P : PITCH CIRCLE DIAMETER FOR MOUNTING THE PUMP
R : SIZE OF HOLE ON P.C.D.
V : INLET / OUTLET DETAIL IN BSP / BORE